Unauthorized Trespass Essay Example | Topics and Well Written Essays - 1000 words

Unauthorized Trespass - Essay Example It was around 2am when he heard the plaintiff plus another man attempting to break in. the defendant took his shotgun and loaded it, then he poked the barrel via a minute opening in the door, he fired and the plaintiff was hit at a close range of around 5feet on his upper arm, by the armpit and eventually into the chest. Plaintiff pleaded culpable to a number of offences which were committed at that night. Defendant was impeached on charges of injuring/wounding but was later acquitted. Not in favor of the defendant, the plaintiff claimed damages owing to infringement of duty of care in negligence and under Occupier’s Liability Act 1984(sec 1). Held: The defendant was found guilty of significant contributory negligence (one third) since he applied violence to the plaintiff that was beyond reasonable limits allowed for lawful self-defense. The plaintiff was awarded 4,033pounds as compensation for personal injuries, the defendant appealed but this was dismissed by the court of ap peal. The defendant should seek supporting evidence that the cause of action by the plaintiff was founded on illegal or immoral act, self-defense or accident. The property owner by applying comparative negligence as a defense should show that the plaintiff did not apply reasonable care for his own safety; and with reference to a new law that came into effect in 1996, in case the injured party is more than 50% fault for detriment lies with him/her, he/she cannot recover non-economic damages (Zweigert and Kotz 1998).

Polyproplene and KRATON Essay Example | Topics and Well Written Essays - 2000 words

Polyproplene and KRATON - Essay Example The thermoplastic stands up quite well to steam-sterilization and autoclaving, managing to resist physical damage and environmental stress-cracking when exposed to high corrosion chemicals in tests. This result is something one can easily expect due to the ability of the material to be fatigue resistant, have high tensile strength, and unbelievable elongation abilities. Such high material characteristics ensures an almost infinite flex life for polypropylene oriented moldings in integrated hinges, making it quite responsive to injection speed and pressure. The plastic also sets in a shorter time when placed in the mold, which ensures a higher production rate for molders. Polyprolene has proven to be excellent when considering is chemical resistant abilities, abrasion strength, dimensional stability, and high surface gloss. Such unique qualities makes the polymer versatile and suitable for superior strength, grease resistance, and moisture barring in film and fibers. While pre-drying is not necessarily required when molding Injection Molding Polypropylene is molded in standard screw making equipment as these can be done without alteration in normal conditions, filled resins may sometimes require pre-drying. The manufacturing process however, isnt as simple as it sounds. The molder needs to take note of additional considerations such as the cylinder temperature and injection pressure. These two of the most closely related variables that take the forefront of the molding parameters will be discussed in the succeeding paragraphs. The most advisable temperature range for cylinders are between 400- 570Â °F. Normally the temperature should be 25-50Â °F above the normal temperature when molding polypropylene. However it should not be molded above 570Â °F so the normal range for molding would be kept anywhere between 400-525Â °F. The cylinder temperature is best kept with the hopper or feed section lower than the nozzle at 30-50Â °F.